How to Flush a Reno Water Heater

Posted by on Jan 17, 2014 in Water Heater Repair Reno

Ok, so it is not an attractive water heater upkeep task, but it does need a little cleaning up from time to time. Yes, today Water Heater Repair Reno is going to instruct one on the best ways to flush out a water heater. Some recommend doing this as soon as every one to three years, we feel it is best to do so when a year. Doing this is not a difficult or time consuming job – heck, let the kids help even.

Why Flush a Reno Water Heater?

If it is last the advised life span of the unit, it needs to have some kind of routine flushing done. Doing so will clearly assistant in having it run as efficiently as possible, which also suggests saving cash on the expense of running the darn thing. That alone should be a sufficient reason we feel!

In terms of water heater upkeep, flushing it will get rid of the buildup of mineral deposits that natural occurs inside the water storage tank. If one has ever had loud sounds, popping, gurgling, mini-explosion sounds, that is an indicator that there is too much sediment inside the tank. This flushing process will assist make sure that the tank heats up water a lot more quietly.

Step 1. If it is an electric water heater, turn the power off in the main electric breaker box and turn the cold water supply off. If it is a gas heater, it is ok to leave the gas on – just turn the water off. Though, turn the thermostat setting dial to the pilot setting (make a note to keep in mind exactly what it was originally set at though for later). Then, whichever faucet the water heater supplies is closest has to be opened. This is usually simpler than opening the pressure relief valve, but one can do that instead.Water Heater RepairReno

Step 2. At the bottom of the water heater is a drain valve that a yard watering hose can be attached to. There might be a cover over it depending upon the maker. Think about turning the heat to the pilot setting several hours before flushing it if one desires so the water isn’t going to be as hot when it is drained. If that is not a choice that’s fine, simply ensure the yard hose used is in great shape to hold up against the greater temperature water.

Run the hose outside away from your home or if the water has cooled, one can drain the tank into containers.

Step 3. Open the water heater’s drain valve and start draining the water. For whatever reason the drain valve is normally made from plastic, so if one has an older water heater (and one that has actually not been drained since before time started) it may stick a little. Simply beware to not break the plastic (which is why it would be good if the darn thing was NOT made of plastic).Water Heater Repair Reno NV

Once the drain valve is open, likewise open the pressure relief valve on the unit. Water will (a minimum of it ought to if it pressure relief valve is working effectively) flow some from it. Attempt to let is flow stable and not too fast so it stirs up the sediment in the water heater. We want the sediment to drain out the bottom from the hose.

If draining in a container, even if having the hose drain into a container beyond the garage or basement where the water heater is found, fill a bucket and let it sit to see if the water is clear or if there is sediment, which will usually look like sand in the bottom of the bucket. Simply keep draining it up until the water is clear.

Step 4. Close the drain on the bottom of the storage tank and close the pressure relief valve if it is still open.

Step 5. Turn the supply of water on once more to fill the tank. Once it is full once again, slowing open the pressure relief valve once more to get some excess air out of the tank. Then, open a hot water faucet in your home to get much more air out of the system.

Step 6. Let the hot water in the bathtub run till a full stream is streaming out. As soon as that happens, it is ok to turn the power back on if it is an electric water heater, or reset the temperature level setting for a gas water heater. Undoubtedly, turn the bathtub faucet off. In about 20 minutes, the hot water ought to be heated once again.

There you go! Water Heater Repair Reno NV is here to respond to any concerns you might have. Next take a look at our post on what to do if one has no hot water.

Enhanced by Zemanta